IP profile editor: H323 Generator
Starting delay. Initial waiting time-period between the
starting of the execution of the profile and the launching of the call.
An empty field means an infinite value of time.
Execution number. Number of consecutive executions of the call; must have a finite, non-null value.
Delay between exec. Delay between the end of the previous
execution and the launching of the next execution of the call.
Dest. IP address. Remote IP address in use if case of:
- no H225.0 RAS.
- H225.0 RAS and Pregranted ARQ mode recognized by the H323 emulator..
If this field contains 0.0.0.0, a LRQ message (whose content
should be configurated) will be sent to the Gatekeeper.
RAS. Access to the RAS settings specific to the current
outgoing call as Admission Request, ... (used only if H225.0 RAS
is initialized).
Call establishment. With the following step in sequence:
- Send SETUP... Message transmission.
Access to editing the attached buffer of IE(s).
Call active. With the specification of the active source to be
connected and the transmission mode resulting in duration parameters.
- Active source. Data source to be connected:
- None. No data source.
- RTP Simulator.
An RTP profile must be selected from a choice list.
- PESQ. Wav file selected
from a choice list.
PESQ measurement is carried out on the Tx/Rx RTP data flows at the end of the profile execution
according to the following settings:
- Analog properties (with Auto
mode) set in the
Protocol filter defined within the profile.
- configuration file set as WI_ANALOG by Clarinet-Init
- Source selection. For some data source type, a complementary selection
must be done.
- Transmission mode.
- Send continuously for a duration. The call is automatically cleared when the duration
expires.
An empty field means an infinite value of time.
- Send number of time(s) and clear after delay. The selected data source is transmitted, for the number
of times as defined. And then, after the delay expiry, the
call is
automatically cleared.
An empty field means an infinite value of the delay.
Call clearing. With the following step in sequence:
| 