SS#7 ISUP signalling behaviour: Responder


Incoming call rejected

Call clearing. With the following step in sequence:

  • Send REL... Message (Release Complete) transmission.
    Access to editing the attached buffer of parameter(s).


Incoming call accepted

Call establishment. With the following steps in sequence:

  • Delay before response. Delay before sending the first validated message.
    An empty field means an infinite value of time
  • Send message. Validation of the transmission of the related message.
    • No. The message will not be sent.
    • Yes. The message will be sent in sequence.
  • Send ACM... Message (Address Complete) transmission if validation.
    Access to editing the attached buffer of Parameter(s).
  • Send CPG... Message (Call Progress) transmission if validation.
    Access to editing the attached buffer of Parameter(s).
  • Send CON... Message (Connect) transmission if validation.
    Access to editing the attached buffer of Parameter(s).
  • Send ANM... Message (Answer) transmission after delay.
    Access to editing the attached buffer of Parameter(s).
    •

    Active state. With the specification of the source to be connected and the duration.

    • Active source. See the choice list. Only significant in the One SP + B Channels emulation mode.
      Source to be connected in the switched B channel(s) during the active state of the call.
    • Data state duration. If this duration expires, the call is automatically cleared.
      An empty field means an infinite value of time.

    Call clearing. With the following steps in sequence:

    • Send REL.Message (Release) transmission, if the called party clears the call after the data state duration.
      Access to editing the attached buffer of Parameter(s).
    • Send RLC. Message (Release Complete) transmission, if the calling party clears the call.
      Access to editing the attached buffer of Parameter(s).


    Copy/Paste functions

    The Copy ISUP xxx buffer and Paste ISUP xxx buffer functions allow to duplicate the contents of a particular message to an other one (in the same profile or a different one).


    Choice list of data sources

          None No data source connected.
    Loop Data echoed TD-RD.
    Handset To use the telephone handset (Speaker + Micro) connected to the HANDSET connector.
    A Cofidec resource is automatically connected and used.
    BERT 511 Bit error rate test - 511 bits pattern.
    BERT 511+ Bit error rate test - 511 bits pattern with error counter details.
    BERT 2047 Bit error rate test - 2047 bits pattern
    BERT 2047+ Bit error rate test - 2047 bits pattern with error counter details.
    BERT 2**15 Bit error rate test - 32767 bits pattern.
    BERT 2**15+ Bit error rate test - 32767 bits pattern with error counter details.
    TRANSIT TRANSIT interface with selection of the used TS's.
    TRANSDATA TRANSDATA interface with automatic TS switching from/to the current interface.
    Cofidec 1 Digital input/output of the Cofidec 1.
    Cofidec 2 Digital input/output of the Cofidec 2.
    Byte-TS /Wav Byte-TS or wav file selected from a choice list.
    64 Kbits data source (as speech, ...).
    PESQ Wav file selected from a choice list (64 Kbits data source).
    PESQ measurement is carried out on the Tx/Rx data flows at the end of the profile execution according to the following settings:
    • Analog properties set in the Protocol filter defined within the profile
    • configuration file set as WI_ANALOG by Clarinet-Init

    Source selection. For some data source type, a complementary selection area must be accessed.

     

    home     Quick start     Specifications     Connections     Features     How to?     Notes     Search     Site Map

    updated:  27-Feb-04