QSIG Emulator configuration - QSIG
Initialize GFT-Control
 No. The
GFT emulator is not used. Yes.
The GFT-Control is initialised (see Qsig_gft_simulation
note for configuration and use ).
Call
establishment
- Called party number digits. Two limit lengths are used by the dialing process:
- Min. Minimum number of digits to be received.
- Max. Maximum number of digits to be received.
- Send CONNECT ACK.
Access to editing the attached buffer of IE(s).
Message transmission if validation:
- No.
The message will not be sent.
- Yes.
The message will be sent.
- Wait for CONNECT ACK.
- No.
The occurence of the message is not checked.
- Yes.
Waiting for the message after sending CONNECT.
- Allow modif. of channel id. IE. defined for the configuration of
calls in the profile.
- No.
The Channel Id IE's cannot be updated by the emulator.
- Yes.
The Channel Id IE's are updated if necessary by the emulator.
- Send DISC/RELEASE. Message transmission
for call clearing on timer expiry.
Access to editing the attached buffer of IE(s).
Timers. Value of time-limits specified for QSIG.
Time-slots
available. Allocation list of TS's which are used as bearer channels.
Transit PINX.
- No.
The Clarinet interface is used as an End PNX.
- Yes.
2 Clarinet interfaces managed by a single
profile (see list of template profiles), are used as Transit PNX.
Transit counter max value. A value must be defined for use in case of
Transit PNX.
List of PINX address fields. Several addresses can be defined for implementing the
Transit signalling behaviour.
- NPI/TON. Number Plan Identification/ Type Of Number
A type must be selected in the choice list :
- Unknown - Unknown
- Public - xxxx
- Private - xxx
- Number Digits. IA5 values.
If PNX is a Transit PNX, local numbers (i.e numbers for which PNX acts as
End PNX), begin with the defined prefix.
| 