Filter editor: Call Reference value
Selecting conditions
can be defined by value(s ). See features.
Counting specifications ( for Statistics )
can be defined by value(s ). See features.
Their use is based on the following rules:
- The different selecting conditions in the panel are exclusive.
- The auto mode is not available within a Display action (or Counter
specifications).
Call reference Value. A value condition can be directly edited.
 Yes. The value condition is
selected. No. The value condition is
not selected.
Call reference Auto. A value condition can be indirectly defined.
- Yes. The auto value
condition is selected.
- No. The auto value condition
is not selected.
The value of the Call reference to be used as a selecting condition is
automatically determined from the monitoring of the protocol sequence upon
recognition of a matching message type with an IE content.
- Message.
Access to the choice list of the message types of the protocol layer. A
message type MUST be selected.
- Information element.
Access to the choice list of IE types. A selection MUST be done :
- Any IE Any IE type may include the selecting string.
- IE type The particular IE type is used as the selecting
condition.
- IE contents.
- Ascii... Edition in ASCII mode of a
selecting string of bytes which must be a partial or the full content of
the selecting IE of the selecting message.
- Hexa... Edition in hexadecimal mode
of a selecting string of bytes which must be a partial or the full
content of the selecting IE of the selecting message.
When the matching condition occurs:
- Only the messages with the related Call reference value will be selected
until the last one ending the communication.
- The automatic recognition becomes inactive until the last message
ending the communication.
| 