SS#7 Emulator configuration - ISUP
Destination point code. Remote signalling Point Code used in DPC field of transmitted
messages.
A value must be defined.
In ANSI, enter value parts as Network Identifier, Network Cluster and Network
Cluster Member.
Circuits Identification Code. List of CIC's in use. Range can be
defined.
Comma is to be used as a separation character for successive insulated circuit
numbers and/or ranges of circuits.
CIC allocation for outgoing calls is carried out according to the following
rules :
- If OPC > DPC, first even CIC value found available starting from the
lowest one.
Otherwise, first odd value found available starting from the lowest one ...
- If DPC > OPC, first odd CIC value found available starting from the
lowest one.
Otherwise, first even value found available starting from the lowest one ...
Bearer circuits association. Only available in the One SP + B Channels emulation mode.
Bearer channel(s) switched by outgoing and incoming calls can be managed either on
the
current Clarinet interface or on a set of several Clarinet interfaces.
Availability of TS's as bearer channels with associated CIC values must be defined for each relevant
Clarinet by Specification
access.
Timers. Value of time-limits specified in Q764-ISUP
specification.
Exchange type. To be chosen within the following list:
BICC selection. Special implementation of emulation mode translated
from ISUP to BICC..
-
- Related topics:
- Protocol: SS7 - ITU-ISUP
| 