|
| |
IP profile editor: Initialize PPP emulator
Synchronous mode
 No. PPP uses asynchronous
mode (HDLC-like frame over V120). Yes.
PPP uses synchronous mode (HDLC frame, AAL5 over ADSL).
Initial Frame Check Sequence. FCS type of the PPP frames to be
received at
first during the
negotiation of LCP Configuration options, and further. Replaced by Frame Check Sequence,
if negotiated, during the Authentication and Network-Layer Protocol phases.
Counters and Timers
- Restart Counter: max configure. Indicates the number of Configure-Request packets
sent without receiving a Configure-Ack, Configure Nack or Configure-Reject packet before
assuming that the peer is unable to respond. Typical value is 10.
- Restart Counter: max terminate. Indicates the number of Terminate-Request packets
sent without receiving a Terminate-Ack packet before assuming that the peer is
unable to
respond. Typical value is 2.
- Restart Timers. Timer used for transmission of Configure-request or
Terminate-Request packets. Typical value is 3 sec.
Protocol options
- AUTH. Access to editing the Authentication
configuration options.
- LCP. Access to editing the Link Control
configuration options.
- NCP. Access to editing the IP
Control configuration options (addresses, compression).
|
